Tongue And Groove Cutter For Table Saw

In general cutting a dado joint using a table saw involves lowering the blade to the required depth and making judicious use of the table saw s fence to guide the wood.

Tongue and groove cutter for table saw.

Generally speaking it s easier to cut the groove of a t g joint first then mill. For example dewalt sells a special dado set blades for table saws. Turn the board around and make another pass. Every woodworker should be familiar with cutting them on the table saw.

The tongue and groove joint can be easily created using a router with a matched set of router bits or on a table saw using a stacked dado blade set. Straight bit and rabbeting bit step 1. Using the table saw is easiest when all the material stock is the same thickness. You can do it all at the router table easily with three different cutter approaches.

I use the two outside cutters to produce a 1 4 cut width when working 3 4 stock. Mainly used for tongue and groove joints. Set the fence on the router table so that the bit will cut approximately through the center of the board. The cuts made when creating the two mating workpieces of a tongue and groove joint are non through cuts meaning that the saw blade never goes all the way through the wood.

Cutting the narrow centered groove and the corresponding tongue to fit into it doesn t take a dado blade and table saw. The same bit can be used to cut both pieces of the joint cut the groove first. On the table saw to produce a tongue and groove on the table saw use a dado cutter rather than your everyday blade unless your stock is 3 8 or less in thickness. Tongue and groove joints are commonly made on a table saw the best method in cutting tongue and groove joints for floor panels is through the shaper.

The tongue and groove is one of the most basic and useful joints. Tongue groove shaper cutter sort by featured best selling alphabetically a z alphabetically z a price low to high price high to low date new to old date old to new grid view list view. In our case the legs are much thicker than the rails so we can t flip the boards end for end to center the groove. The easiest method and the one i most commonly use is to use the table saw for both the tongue and the groove.